Lanier Copier System Edition - Page 131

Operating Instructions Maintenance Guide 2 Copier System Edition
60
Possible Cause Solutions
Is the Data In indicator blinking
or lit after starting the print job?
If not blinking or lit, the data is not being sent to the printer.
❖
❖❖
❖ If the printer is connected to the computer using the interface
cable
Make sure the printer port settings are correct. For a parallel port connection,
port LPT1 or LPT2 should be set.
• Windows 95/98/Me
A
Click [Start], point to [Settings], and then click [Printers].
B
Click to select the icon of the printer. Next, on the [File] menu, click
[Properties].
C
Click the [Details] tab.
D
Check the [Print to the following port] box to confirm that the correct
port is selected.
• Windows 2000
A
Click [Start], point to [Settings], and then click [Printers].
B
Click to select the icon of the printer. Next, on the [File] menu, click
[Properties].
C
Click the [Port] tab.
D
Check the [Print to the following port] box to confirm that the correct
port is selected.
• Windows NT 4.0
A
Click [Start], point to [Settings], and then click [Printers].
B
Click to select the icon of the printer. Next, on the [File] menu, click
[Properties].
C
Click the [Port] tab.
D
Check the [Print to the following port] box to confirm that the correct
port is selected.