Lanier Copier System Edition - Page 275

Operating Instructions Administrator Reference 2
46
H
HH
H
Click to select [Bindery Mode], type the file server name into the [File Server Name:] box, and
then click [Next].
In the [File Server Name:] box, type the name of the file server in which a print server is to be created.
You can also select a file server from the list that appears by clicking [Browse].
I
II
I
Type the print server name into the [Print Server Name] box, printer name into the [Printer
Name] box, and print queue name into the [Print Queue Name] box, and then click [Next].
• In the [Print Server Name] box, type the name of the NetWare print server within 47 characters.
• In the [Printer Name] box, type the name of the NetWare printer.
• In the [Print Queue Name] box, type the name of the print queue to be added to NetWare.
J
JJ
J
After confirming the settings, click [Next].
The settings take effect, and the NIB setup tool exits.
K
KK
K
Exit SmartNetMonitor for Admin.
L
LL
L
Turn the printer power off and on.
Note
❒ To confirm that the printer is configured correctly, type as follows from the command prompt.
F:> USERLIST
❒ If the printer works as configured, the name of the print server appears as an attached user.