Operating Instructions Administrator Reference 2
204
Protocol
Use the set command to allow/prevent remote access for each protocol.
msh> set protocol {up | down}
Note
❒ If you prohibit remote access using TCP/IP and then log out, you cannot use remote access. If this
was a mistake, you can use the printer operation panel to allow access by TCP/IP.
❒ When you prevent access via TCP/IP, you are also prevented from using lpr, ftp, rsh, diprint, web,
snmp and ipp.
Protocol
appletalk
tcpip
netware
netbeui
lpr
ftp
rsh
diprint
web
snmp
ipp
"up" means active and "down" means inac-
tive.
To Next Page
Loading...
