Operating Instructions Copy Reference <Advanced Features>
110
General Features
5
/
5
❖
❖❖
❖ Clear Bypass Mode
Set this function to whether or not the settings of the Bypass Tray are cleared, when performing
Auto Clear after turning the power on or when performing reset.
Note
❒ Default: Clear
❖
❖❖
❖ Color Mode Priority
Set this function to whether or not copy by prioritizing either “Black & White” or “Full Color”.
Note
❒ Default: Full Color
❖
❖❖
❖ Two-color Mode Priority
Set this function to whether or not to prioritize “Red & Black” or “Two-color” when using the
“Two-color” modes.
Note
❒ Default: Red & Black
❖
❖❖
❖ Auto Image Density Priority
Set this function to whether or not use Automatic Density, when performing Auto Clear after turning
the power on or when performing reset.⇒ “Auto Image Density”, Basic Features manual
Note
❒ Default
• Full Color / Two-color: OFF
• B & W / Single Color: ON
To Next Page
