Operating Instructions Scanner Reference
104
Cannot select over 30 files at the same time. To select more than 30 stored files, divide the operation
into several times.
Cannot use destination list because the stored destinations
have been found over 200.
More than 200 destinations were programmed. Keep the
number at 200 or less.
Destination and sender list update has been failed.
Try again.
Check whether the delivery server has started operation.
Exceeded max. data capacity.
Check the scanning resolution.
Specify the scan size and resolution again. Note that it
may not be possible to scan very large originals. ⇒ p.98
“The Relationship between the Resolution and the Data
Size”
Exceeded max. file capacity.
Delete the unnecessary stored files.
The maximum number of files that can be stored is 3000.
Delete unneeded files.
Exceeded max. number of pages (500 pages) per file.
Do you want to store the scanned pages as 1 file?
The maximum number of pages per file is 500. Specify
whether to use the data or not. Scan the page that could
not read once more as a new file.
Exceeded max. number of stand-by files.
Try again after the data transmission is completed.
There are 50 standby files in the sending queue for the de-
livery server. Wait until files have been sent.
Exceeded max. page capacity per file.
Only the scanned data will be transmitted.
Scan the remaining data after transmission.
Because the number of scanned pages reaches the maxi-
mum value for delivery, only the data already scanned is
transmitted. Retransmit the remaining pages.
Memory is full.
Cannot scan.
Because of insufficient hard disk capacity, the first page
could not be fully scanned. Try one of the following
measures.
• Wait for a while and retry the scan operation.
• Reduce the scan area.
• Delete unneeded stored files.
Message Causes and Solutions
To Next Page
Loading...
