Operating Instructions Scanner Reference
109
[
Error has occurred in the scanner.
] Check whether the scanning settings specified by appli-
cation exceed the setting range of the machine.
[
Error has occurred in the scanner driver.
] • Check whether a network cable is connected correct-
ly to the computer.
• Check whether the Ethernet board of the computer is
recognized correctly by Windows.
• Check whether your computer can use TCP/IP proto-
col.
[
Insufficient memory. Close all applications, then restart
scanning.
]
Terminate the unnecessary application started by the
computer.
[
Insufficient memory. Reduce the scanning area.
] • Reset the scan size.
• Lower the resolution.
• Set with no compression. ⇒ p.35 “Making Scanner
Settings”
Note
❒ The chart "The Relationship between the Res-
olution and the Scanning Area" in Help for
halftone scanning might not always apply.
Scanning cannot be performed if large values
are set for brightness when using halftone or
high resolution.
❒ When paper misfeed occurs in the machine
during printing, scanning cannot be per-
formed. In this case, after the misfed paper
has been removed, proceed with scanning.
Message Causes and Solutions
To Next Page
Loading...
