Operating Instructions Maintenance Guide 2 Copier System Edition
46
❖
❖❖
❖ Alert Messages
Messages Description Solution
Add Toner
No toner.
Open the cover as shown and replace
Toner Cartridge by following instruc-
tions shown inside the cover.
The indicated toner cartridge(s) is/are
empty.
Replace the indicated toner car-
tridge(s).
See "Replacing Consumables and
Maintenance Kit" in Maintenance
Guide 1.
Cannot communicate with external
server.
Contact key operator.
There is a problem with the Network
settings.
Connect the machine to the Network
correctly, and then make sure the
server's power switch is on.
If the message appears again, contact
your key operator, sales or service
representative.
Cannot connect with network.
Check settings of IP Address.
There is a problem with the Network
settings.
Set a IP address correctly.
See "Configuring the Network with
the Control Panel" in Administrator
Reference 1.
If the message appears again, contact
your sales or service representative.
Cannot connect with network.
Contact key operator.
There is a problem with the Network
settings.
Connect the machine to the Network
correctly, and confirm other device's
power switch is turned on. If the mes-
sage appears again, contact your sales
or service representative.
Cannot print file stored in PC.
Load paper on #.
The paper in tray # ran out while
stored files were being printed.
#: tray number
Load paper in tray #.
To Next Page
Loading...
