Operating Instructions Maintenance Guide 2 Copier System Edition
50
Fusing Unit Setting Error
Fusing Unit is not set properly.
Open the part as shown and set the
unit.
The fusing unit is not set correctly, or
is not set.
Set the fusing unit correctly.
See "Replacing Consumables and
Maintenance Kit" in Maintenance
Guide 1.
Hard disk is full.
Delete unnecessary files.
The maximum Hard disk drive area
size has been exceeded.
Delete the unnecessary stored file.
Hole punch receptacle is full.
Empty it.
The punch waste box is full of punch
chips.
Remove the punch chips from the
punch waste box.
See p.92 “Removing Punch-hole
Chips”.
When the message appears even the
waste box is not full, remove the
Punch- hole chips on the top of the
punch waste box.
See p.93 “When the message appears
even after removing the Punch-hole
chips”.
Messages Description Solution
To Next Page
Loading...
