Operating Instructions Maintenance Guide 2 Copier System Edition
51
LCT has a problem. Turn Main Pow-
er Switch off then on. If the error ap-
pears again, call service
representative.
The LCT (Large Capacity Tray) is
malfunctioning.
Turn the main power switch off and
then on. If the message appears again,
contact your sales or service repre-
sentative.
Reference
Before turning the main pow-
er switch, see "Turning Off
the Main Power" in Adminis-
trator Reference 1.
Load following paper in Tray #, or
select another tray and press [Contin-
ue].
To cancel job, press [Reset].
Required:<xxx> <yyy>
The indicated paper input tray is out
of paper.
#: tray number
<xxx>: paper size
<yyy>: paper type
Load paper into the indicated paper
input tray.
NV-RAM has a problem. The printer identified a memory
switch (User Account Enhance Unit)
error.
Replace the User Account Enhance
Unit.
Original Misfeed
Original was misfed at following
point.
Open the part as shown, then remove
it.
There is a misfeed in the indicated
point.
Remove the misfed paper.
See p.68 “Removing Misfed Paper”.
Output tray has been changed. The output tray has been changed be-
cause the selected output tray cannot
handle the paper size in use.
Set the correct output tray.
Messages Description Solution
To Next Page
Loading...
