Operating Instructions Maintenance Guide 2 Copier System Edition
52
Paper in duplex unit.
Open cover and remove paper.
There is a misfeed in the Duplex Re-
versal Unit.
Remove misfed paper.
See p.81 “When "Paper Misfeed: Z1"
Appears”.
Paper in staple tray.
Open finisher cover and remove pa-
per.
There is a misfeed in the optional 2
Tray Finisher.
Open the finisher cover and remove
misfeed.
See p.76 “When "Paper Misfeed: R"
Appears”.
Paper Misfeed
Paper was misfed at following point.
Open the part as shown and remove
it.
There is a misfeed in the indicated
point.
Remove misfed paper.
See p.68 “Removing Misfed Paper”.
Paper remains on staple tray.
Remove it.
There is still paper in the staple tray. Remove paper from the staple tray.
Paper size and type are mismatched.
Select another tray from followings
and press [Continue].
To cancel job, press [Reset]. Paper
size and type can also be changed in
User Tools.
Required:<xxx> <yyy>
The paper size and the paper type set-
tings of the input paper tray are not
the same as those of the tray selected
by the printer driver, when Auto Tray
Select feature is on.
<xxx>: paper size
<yyy>: paper type
Load the required paper size and type
into the paper input tray.
Messages Description Solution
To Next Page
Loading...
