Lanier Copier System Edition - Page 289

Operating Instructions Administrator Reference 2
60
C In the [Print Server name] box, type the name of the print server.
Important
❒ Use the same name as that specified using the NIB Setup Tool. (Step
F
).
D Click [Define additional properties] to check a box, and click [Create].
M
MM
M
Assign the printer to the created print server as follows.
A Click [Assignments], and click [Add] in the [Assignments] group.
B In the [Available objects] box, click the queue created in the step
J
, and click [OK].
C In the [Printers] group, click the printer assigned in step B
BB
B , and click [Printer Number].
D Type the printer number and click [OK].
Important
❒ Use the same number as that specified as Remote Printer No. using the NIB Setup Tool.
(Step
F
-E).
E After confirming the settings, click [OK].
N
NN
N
Start the print server by typing the following from the console of the NetWare Server.
If it is running, restart it after exiting it.
❖
❖❖
❖ To exit
CAREE: unload pserver
❖
❖❖
❖ To start
CAREE: load pserver print_server_name