Operating Instructions Administrator Reference 2
206
Network Interface Board configuration settings information
Use the show command to display the Network Interface Board configuration settings.
msh> show [-p]
Note
❒ Add "-p" to the show command to have the information displayed one screen at a time.
Reference
For more information about the meaning of the data returned with this command, see p.230 “Con-
figuring the Network Interface Board”.
System log information
Use the syslog command to display information stored in the printer's system log.
msh> syslog
Reference
For more information about the displayed information, see p.233 “System Log Information”.
To Next Page
Loading...
