Operating Instructions Administrator Reference 2
207
SNMP
Use the snmp command to display and edit SNMP configuration settings such as the community name.
Note
❒ You can configure from ten SNMP access settings numbered 1–10.
❒ Default access settings 1 and 2 are as follows.
❖
❖❖
❖ Display
Shows the SNMP information and available protocols.
msh> snmp ?
msh> snmp [-p] [registered_number]
Note
❒ If the -p option is added, you can view the settings one by one.
❒ Omitting the number displays all access settings.
❖
❖❖
❖ Community name configuration
You can set the community name of the Network Interface Board.
msh> snmp number name community_name
Note
❒ The community name must consist of 15 characters or less.
Number 1 2
Community name public admin
IP address 0.0.0.0 0.0.0.0
Access type read-only
trap off
read-write
trap off
To Next Page
Loading...
