Operating Instructions Administrator Reference 2
208
❖
❖❖
❖ Access type configuration
You can select the access type from those listed below.
msh> snmp number type access_type
❖
❖❖
❖ Protocol configuration
You should use the following command to set the protocols to active or inactive. If you set a protocol
to inactive, all access settings set to use that protocol are disabled.
msh> snmp {ip | ipx} {on | off}
• "on" means active and "off" means inactive
To change the protocol of an access settings, use the following command. However, if you disabled
a protocol with the above command, making it active here will have no effect.
msh> snmp number active {ip | ipx} {on | off}
Access type Type of access which is permitted
read Read only
write Read and write
trap User is notified of trap messages.
no All access is denied.
To Next Page
Loading...
