Operating Instructions Administrator Reference 2
209
❖
❖❖
❖ Access configuration
You can configure an address of a host depending on the protocols used.
The Network Interface Board accepts requests only from hosts having addresses with access types
of "read-only" or "read-write". Type "0" to have the Network Interface Board accept requests from
any host without requiring a specific type of access.
Command syntax:
msh> snmp number {ip | ipx} address
Note
❒ To specify the TCP/IP protocol, type ip followed by a space and then the IP address.
❒ To specify the IPX/SPX protocol, type ipx followed by a space and then the IPX address followed
by a decimal and then the MAC address of the Network Interface Board.
The following is an example of how to configure registration number 3 with the IP address
192.168.15.16.
msh> snmp 3 ip 192.168.15.16
The following is an example of how to configure registration number 3 with the IPX address
7390A448, and the MAC address 00:00:74:62:5C:65.
msh> snmp 3 ipx 7390A448:000074625C65
To Next Page
Loading...
