Operating Instructions Administrator Reference 2
212
ROUTE
Use the route command to control the routing table.
This command allows you to configure and display routing information. You can change the network
configuration from remote PC using this command.
Note
❒ The maximum number of routing tables are 16.
*1
IP address
Parameter Topics of setting
route add {host | net} destination
gateway
Adds a host/network route to "destination", and a gateway address to "gateway"
in the table. Host becomes the default setting.
route delete {host | net} destina-
tion
Deletes a host/network route from the table. Host becomes the default setting.
route get {destination } Displays only route information corresponding to a specified destination. When
the destination is unspecified, all routing information is displayed.
route active {host | net} destina-
tion
*1
on/off
You can turn the specified destination on or off. Host becomes the default set-
ting.
route flush Deletes all routing information.
To Next Page
Loading...
