Operating Instructions Administrator Reference 2
216
Error: Command Transmission An error has occurred in the engine or
controller.
First, turn the power switch off and
then on. If the message appears again,
call your sales or service representa-
tive.
Error: DIMM Value An error has occurred in the DIMM. First, turn the power switch off and
then on. If the message appears again,
call your sales or service representa-
tive.
Error: Ethernet Board An error has occurred in the Network
Interface Board.
First, turn the power switch off and
then on. If the message appears again,
call your sales or service representa-
tive.
Error: HDD Board An error has occurred in the optional
Hard Disk Drive.
First, turn the power switch off and
then on. If the message appears again,
call your sales or service representa-
tive.
Error: IEEE 1394 Board An error has occurred in the optional
1394 Interface Unit.
First, turn the power switch off and
then on. If the message appears again,
call your sales or service representa-
tive.
Error: Memory Switch An error has occurred in printer. First, turn the power switch off and
then on. If the message appears again,
call your sales or service representa-
tive.
Error: Optional RAM An error has occurred in the optional
Memory Unit.
First, turn the power switch off and
then on. If the message appears again,
call your sales or service representa-
tive.
Messages Description Comments
To Next Page
Loading...
