Operating Instructions Maintenance Guide 2 Copier System Edition
25
❖
❖❖
❖ OHP transparencies
• When printing on OHP transparencies, use the Bypass Tray.
• Load OHP transparencies on the tray with the print side up or they may stick to the Fusing Unit
and cause a misfeed.
• Remove any unused OHP transparencies from the Bypass Tray after you are finished printing.
Leaving them in the tray may cause them to stick together.
• When printing on OHP transparencies, you should select the OHP transparency mode with the
printer driver.
• Confirm that the top of the stack is not higher than the limit mark inside the tray.
• When you print more than one OHP transparency, remove each sheet from the tray before the
next sheet is printed out, or select "Slip Sheet" in the printer driver. For details about using "Slip
Sheet", see the printer driver Help file.
To Next Page
Loading...
