Registration Sensor : Late Jam : Cause Code 017
Target Part/SP No.:Registration Sensor / SP5-803-001
Cause verification Problem Judgement
Execute an INPUT check when there is no paper at the position
of the referenced sensor.
0 :Paper detected
Execute an INPUT check when there is paper at the position of
the referenced sensor.
1: Paper not detected
Solution:
• Clean the sensor.
• Reconnect the connector.
• Replace the sensor.
• Replace the Paper Transport IOB.
• Replace the harness.
Checking paper status, or 1st paper transport roller.
Check if extra thin paper or thick paper exceeding the supported
paper thickness is being used.
Use a supported paper type.
Check if the paper thickness and size are detected correctly. Set the paper thickness and size
to the correct value.
Check if the paper feed tray is not stained with a lot of paper
dust.
Clean the 1st transport roller.
Fusing Entrance Sensor : Late Jam : Cause Code 018
Target Part/SP No.:Fusing Entrance Sensor / SP5-803-011
Cause verification Problem Judgement
Execute an INPUT check when there is no paper at the position
of the referenced sensor.
0 :Paper detected
Execute an INPUT check when there is paper at the position of
the referenced sensor.
1: Paper not detected
Solution:
• Clean the sensor.
6. Troubleshooting
1016
To Next Page
Loading...
Need help?
General
