• 2. and 3. can be disabled using Printer Bit Switch 2-3=1.
• If the "Printer Language" is configured to anything other than Auto, all detection will be disabled.
• An interpreter submits a job page by page to the rasterizer. Therefore, when an interpreter detects
a trigger mid-job, the previous pages will have already been submitted and will be output using the
previously detected PDL.
• If the PDL cannot be detected by the printer system, then the PDL defaults to the one configured in
"Configuration > Printer Basic Settings > Default Printer Language".
The Printer Language setting and Default Printer Language setting in WIM:
PDL Selection and Switching
Three types of PDL selection/switching are performed:
1. PDL selection (PCL5 or PS (including PDF)) at the beginning of the job: performed by the printer
system
5. Software Configuration
676
To Next Page
Loading...
