Ricoh MP C2504 User Manual

NVRAM Data Upload/Download
Uploading Content of NVRAM to an SD card
Do the following procedure to upload SP code settings from NVRAM to an SD card.
• This data should always be uploaded to an SD card before the NVRAM is replaced.
• Make sure that the write protection of an SD card is unlocked.
1. Do SP5-990-001 (SP Print Mode: All(Data List)) before you switch the machine off. You
will need a record of the NVRAM settings if the upload fails.
Make sure to shut down and reboot the machine once before printing the SMC. Otherwise, the
latest settings may not be collected when the SMC is printed.
2. Turn OFF the main power.
3. Remove the SD card slot cover [A].
4. Insert the SD card in Service Slot [A: Lower Slot].
5. Turn ON the main power.
6. Execute SP5-824-001 (NVRAM Data Upload) and then press the "Execute" key.
5. System Maintenance
716

Ricoh MP C2504 Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Print Resolution	1200 x 1200 dpi
Scan Type	Flatbed, ADF
Max Scan Resolution	600 x 600 dpi
Copy Resolution	600 x 600 dpi
Max Paper Size	A3
Duplex Printing	Yes
Memory (RAM)	2 GB
Print Speed	25 ppm (A4)
Copy Speed	25 cpm (A4)
Fax Resolution	200 x 200 dpi
Paper Capacity	1200 sheets
Connectivity	USB, Ethernet, Wi-Fi
Dimensions	587 x 685 x 913 mm
Control Panel	9-inch Smart Operation Panel