Name: Ricoh MP C2504
Brand: Ricoh
Rating: 4 (1 reviews)

To Next Page

To Previous Page

• Replace the motor.

• Replace the Paper Transport IOB.

• Replace the harness.

Checking paper jam, or paper status

Check if there is no double feeding. Fan the paper.

Paper Exit Sensor: Lag Jam: Cause Code 060

Target Part/SP No.: Paper Exit Sensor / SP5-803-008

Cause verification Problem Judgement

Execute an INPUT check when there is no paper at the

position of the referenced sensor.

0 :Paper detected

Execute an INPUT check when there is paper at the position

of the referenced sensor.

1: Paper not detected

Solution:

• Clean the sensor.

• Reconnect the connector.

• Replace the sensor.

• Replace the Paper Transport IOB.

• Replace the harness.

Checking paper jam, or paper status

Check if the leading edge of the paper and the paper feed

guide are wet.

If condensation has occurred inside

the machine, leave the machine idle

for a few minutes to remove

condensation.

Check if there is no double feeding. Fan the paper.

Check if the paper is curled too much.

If the paper is curled too much, switch

on the anti-condensation heater for

paper tray.

Check if extra thin paper or thick paper exceeding the

supported paper thickness is being used.

Use a supported paper type.

Troubleshooting for Transport/Paper Feeding of the Machine

1025

Questions and Answers:

Need help?

Do you have a question about the Ricoh MP C2504 and is the answer not in the manual?

Ricoh MP C2504 Specifications

General