1-153-005 Heat Center Target Temp ENG [100 to 180 / 130 / 1deg/step]
1-153-006 Heat End Target Temp ENG [100 to 180 / 130 / 1deg/step]
1-153-007 Press Target Temp ENG [0 to 200 / 0 / 1deg/step]
1154 [Switch:Rotation Start/Stop]
1-154-001 Judging Method Change *ENG [0 or 1 / 0 / 1/step]
0: On
1: Off
1-154-005 Heater ON Timing *ENG [0 to 250 / 50 / 1 / 10msec/step]
1-154-006 Overshoot Prevent Temp.:SC *ENG [0 to 250 / 180 / 1deg/step]
1155 [Small Size Paper Control]
1-155-001 Print Width *ENG [0 to 300 / 0 / 1mm/step]
1157 [Overshoot Prevent Control]
1-157-001 Decision Time *ENG [0 to 100 / 5 / 1sec/step]
1-157-002 Decision Temp. *ENG [0 to 250 / 185 / 1deg/step]
1-157-003 - *ENG [0 to 300 / 15 / 1sec/step]
1-157-004 Timeout *ENG [0 to 300 / 300 / 1sec/step]
1161 [Shading Plate Control]
1-161-001 Judgment Temp A ENG [0 to 250 / 250 / 1deg/step]
1-161-002 Judgment Temp B ENG [0 to 250 / 250 / 1deg/step]
1-161-003 Position Transition Time ENG [0 to 10000 / 1000 / 1msec/step]
1-161-004 After Transition Time Out ENG [0 to 20000 / 0 / 1msec/step]
1-161-005 Shading Plate Retry Volume *ENG [0 to 100 / 60 / 1pulse/step]
1162 [Shading Plate Control]
3. Engine SP Mode Tables
124
To Next Page
Loading...
