8211 [T:Scan PGS/LS] *CTL These SPs count the number of pages
scanned into the document server.
[0 to 99999999 / 0 / 1]
The L: counter counts the number of pages
stored from within the document server mode
screen at the operation panel, and with the
Store File button from within the Copy mode
screen
8212 [C:Scan PGS/LS] *CTL
8213 [F:Scan PGS/LS] *CTL
8215 [S:Scan PGS/LS] *CTL
8216 [L:Scan PGS/LS] *CTL
• Reading user stamp data is not counted.
• If a job is cancelled, the pages output as far as the cancellation are counted.
• If the scanner application scans and stores 3 B5 sheets and 1 A4 sheet, the S: count is 4.
• If pages are copied but not stored on the document server, these counters do not change.
• If both sides of 3 A4 sheets are copied and stored to the document server, the C: count is 6 and the
L: count is 6.
• If you enter document server mode then scan 6 pages, the L: count is 6.
8221 [ADF Org Feeds]
These SPs count the number of pages fed through the ADF for front and back side
scanning.
001 Front *CTL [0 to 99999999 / 0 / 1/step]
Number of front sides fed for scanning:
With an ADF that can scan both sides simultaneously, the Front side count is the same as
the number of pages fed for either simplex or duplex scanning.
With an ADF that cannot scan both sides simultaneously, the Front side count is the same
as the number of pages fed for duplex front side scanning. (The front side is determined by
which side the user loads face up.)
002 Back *CTL [0 to 99999999 / 0 / 1/step]
Number of rear sides fed for scanning:
With an ADF that can scan both sides simultaneously, the Back count is the same as the
number of pages fed for duplex scanning.
With an ADF that cannot scan both sides simultaneously, the Back count is the same as the
number of pages fed for duplex rear-side scanning.
• When 1 sheet is fed for duplex scanning the Front count is 1 and the Back count is 1.
Controller SP Tables - SP8000
611
To Next Page
Loading...
