2. Remove the SD card slot cover [A].
3. Insert the DataOverwriteSecurity Unit Type M19 SD card in SD card slot 1 [A: Upper Slot].
4. Reattach the SD card slot cover ( ×1).
5. Insert the power cord into the outlet and turn ON the main power.
• When installing more than one SD card, perform the merge operation.
6. Enter the SP mode.
7. Do this step only if you are installing the option on a machine that is already in use (not a
new machine):
• If the customer wishes to continue using the same hard disk, execute all three SP modes
below.
• SP5-801-014 (Clear DCS Setting)
• SP5-832-001 (HDD Formatting (ALL))
• SP5-832-002 (HDD Formatting (IMH))
• If customer wishes to replace the hard disk with a new one, execute SP5-801-014 only.
• If the customer continues using the same hard disk, the overwriting of the data stored on the
disk before the option is installed cannot be guaranteed. It is highly recommended to replace
the hard disk with a new one.
2. Installation
364
To Next Page
Loading...
