3. Remove the toner bottle protection cap [A].
4. Push the toner bottle into the machine slowly.
5. Set the toner bottles (Y, M, and C) in the same way.
6. Close the front cover.
7. Connect the power cord to the machine.
• Use the power cord that is provided with the machine. Do not use any other power cord. Also,
do not use an extension cord.
8. Turn ON the main power.
• Toner Initialization starts. It takes about 5 minutes to fill the toner up.
Be sure to wait long enough. If you do not, Auto Color Calibration (ACC) will take longer.
2. Installation
74
RTB 35
'Invalid firmware is installed'
To Next Page
Loading...
