Operating Instructions Maintenance Guide 2 Copier System Edition
54
Photoconductor Units Setting Error
Photoconductor Units are not set
properly: Black, Yellow, Magenta,
Cyan
Open the part as shown and set the
unit.
The indicated Photoconductor
Unit(s) is/ are not set correctly, or is
not set.
Set the indicated Photoconductor
Unit(s) correctly.
See "Replacing Consumables and
Maintenance Kit" in Maintenance
Guide 1.
Problem with the hard disk.
Call service.
The printer identified a hard disk
drive error.
Turn the main power switch off and
then on. If the message appears again,
contact your sales or service repre-
sentative.
Reference
Before turning the main pow-
er switch, see "Turning Off
the Main Power" in Adminis-
trator Reference 1.
Problem with IEEE 1394 board.
Call service.
The printer identified an IEEE1394
Board error.
Contact your sales or service repre-
sentative.
Problem with the printer module.
Call service.
The printer identified a DIMM sum
value error.
Contact yoursales or service repre-
sentative.
Punch has been cancelled. The setting of punch function has
been cancelled.
Verify that the paper orientation, pa-
per feed direction and the setting of
punch where you desire.
Messages Description Solution
To Next Page
Loading...
