Operating Instructions Maintenance Guide 2 Copier System Edition
55
Replacement of Development Unit is
required.
Replace Development Unit(s).
It is time to replace the color or the
black development Unit(s).
Replace the color or the black Devel-
opment Unit(s).
See "Replacing Consumables and
Maintenance Kit" in Maintenance
Guide 1.
Replacement of Photoconductor Unit
is required.
Replace Photoconductor Unit.
It is time to replace the color or the
black Photoconductor Unit.
Replace the color or the black Photo-
conductor Unit.
Depending on your service contract,
contact your sales or service repre-
sentative.
See "Replacing Consumables and
Maintenance Kit" in Maintenance
Guide 1.
Reset duplex unit correctly. The duplex paper feed unit is not set
correctly or is not set.
Remove and re-install the duplex pa-
per feed unit correctly.
See "Setting Up" in the Setup Guide.
Reset tray # correctly, or select anoth-
er tray and press [Continue].
To cancel job, press [Reset].
Required:<xxx> <yyy>
The indicated paper input tray is not
set correctly, or is not set.
#: tray number
<xxx>: paper size
<yyy>: paper type
Set the indicated paper input tray cor-
rectly.
RPCS graphic error. The graphic is not initialized because
the graphic memory was not re-
served.
Replace the installed memory.
Messages Description Solution
To Next Page
Loading...
