Operating Instructions Maintenance Guide 2 Copier System Edition
56
RPCS memory overflow. The printer memory is not initialized
because the CDC memory was not re-
served via the system call.
Replace the installed memory.
RPCS syntax error. The printer identified a syntax error.
This error results from; data trans-
mogrification caused by the transmis-
sion path problem, data interruption,
data transmission from other drivers,
etc.
Be sure to use the correct driver.
SDRAM module could not be recog-
nized.
Call service.
The printer identified an optional
SDRAM error.
Remove and re-install the optional
SDRAM.
If the message appears again, contact
your sales or service representative.
Selected paper tray is in use for an-
other function. Please wait.
The input paper tray selected by the
printer driver is being used for anoth-
er function.
Wait until the job will be completed.
Shift tray has a problem. Call service
representative.
Malfunction occurs when using the
Shift function
Contact your sales or service repre-
sentative.
Staple has been cancelled. The staple feature has been cancelled. Verify that the paper orientation and
layout is properly set, and make sure
whether your desired settings or fin-
isher is selected.
Staple is almost empty. Staple is almost empty in the stapler. Replace staples.
Staple unit has a problem. Call serv-
ice representative.
There is a problem with the staple
unit.
Contact your sales or service repre-
sentative.
Messages Description Solution
To Next Page
Loading...
