Operating Instructions Maintenance Guide 2 Copier System Edition
64
It takes too much time to resume print-
ing.
The data is so large or complex that it takes time to process it. If the Data
In indicator is blinking, data processing is being performed. Just wait until
it resumes.
The printer might be set to the Energy Saver mode. In the Energy Saver
mode, the printer has to warm up before printing starts. This takes time. To
cancel the Energy Saver mode, select "Off" for "Energy Saver 1" in the
System Settings menu.
Multiple pages are fed through the
printer at once.
Paper misfeeds easily when the Paper Feed Roller is dirty. Contact your
sales or service representative to replace the Paper Feed Roller.
Output are not delivered to the selected
tray you require.
When using the Bypass Tray, the size selected on the display panel might
be different from actual paper size. Select the correct paper size.
See p.12 “Paper and Other Media Supported by This Machine”.
When you are using a Windows operating system, the printer driver set-
tings override those set using the control panel. Set the desired output tray
using the printer driver.
See the printer driver's Help file.
Paper misfeeds occur frequently. Check that the side guide of the paper tray is locked.
See p.12 “Paper and Other Media Supported by This Machine”.
The paper size and feed direction of the paper in the Bypass Tray might not
be the same as those you selected with the control panel. Check the settings
on the control panel, and load paper of the correct paper size and feed di-
rection.
See p.12 “Paper and Other Media Supported by This Machine”.
Check that the paper guide of the paper tray is attached properly.
Status Possible Causes, Descriptions, and Solutions
To Next Page
Loading...
