This means LDVAL1 and LDVAL3 must be written with 0x0003E7FF and 0x0016E35F
respectively.
The interrupt for Timer 1 is enabled by setting TCTRL1[TIE]. The timer is started by
writing 1 to TCTRL1[TEN].
Timer 3 shall be used only for triggering. Therefore, Timer 3 is started by writing a 1 to
TCTRL3[TEN]. TCTRL3[TIE] stays at 0.
The following example code matches the described setup:
// turn on PIT
PIT_MCR = 0x00;
// Timer 1
PIT_LDVAL1 = 0x0003E7FF; // setup timer 1 for 256000 cycles
PIT_TCTRL1 = TIE; // enable Timer 1 interrupts
PIT_TCTRL1 |= TEN; // start Timer 1
// Timer 3
PIT_LDVAL3 = 0x0016E35F; // setup timer 3 for 1500000 cycles
PIT_TCTRL3 |= TEN; // start Timer 3
40.6
Example configuration for chained timers
In the example configuration:
• The PIT clock has a frequency of 100 MHz.
• Timers 1 and 2 are available.
• An interrupt shall be raised every 1 minute.
The PIT module needs to be activated by writing a 0 to MCR[MDIS].
The 100 MHz clock frequency equates to a clock period of 10 ns, so the PIT needs to
count for 6000 million cycles, which is more than a single timer can do. So, Timer 1 is
set up to trigger every 6 s (600 million cycles). Timer 2 is chained to Timer 1 and
programmed to trigger 10 times.
The value for the LDVAL register trigger is calculated as number of cycles-1, so
LDVAL1 receives the value 0x23C345FF and LDVAL2 receives the value 0x00000009.
The interrupt for Timer 2 is enabled by setting TCTRL2[TIE], the Chain mode is
activated by setting TCTRL2[CHN], and the timer is started by writing a 1 to
TCTRL2[TEN]. TCTRL1[TEN] needs to be set, and TCTRL1[CHN] and TCTRL1[TIE]
are cleared.
Example configuration for chained timers
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
1038 NXP Semiconductors
To Next Page
Loading...
Need help?
General
