EasyManuals Logo

NXP Semiconductors K22F series User Manual

NXP Semiconductors K22F series
1407 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #992 background imageLoading...
Page #992 background image
Table 39-9. Software ouput control behavior when (COMP = 1)
CH(n)OC CH(n+1)OC CH(n)OCV CH(n+1)OCV Channel (n) Output Channel (n+1) Output
0 0 X X is not modified by SWOC is not modified by SWOC
1 1 0 0 is forced to zero is forced to zero
1 1 0 1 is forced to zero is forced to one
1 1 1 0 is forced to one is forced to zero
1 1 1 1 is forced to one is forced to zero
Note
• The CH(n)OC and CH(n+1)OC bits should be equal.
• The COMP bit must not be modified when software output
control is enabled, that is, CH(n)OC = 1 and/or CH(n
+1)OC = 1.
• Software output control has the same behavior with
disabled or enabled FTM counter (see the CLKS field
description in the Status and Control register).
39.4.14
Deadtime insertion
The deadtime insertion is enabled when (DTEN = 1) and (DTVAL[5:0] is non- zero).
DEADTIME register defines the deadtime delay that can be used for all FTM channels.
The DTPS[1:0] bits define the prescaler for the system clock and the DTVAL[5:0] bits
define the deadtime modulo, that is, the number of the deadtime prescaler clocks.
The deadtime delay insertion ensures that no two complementary signals (channels (n)
and (n+1)) drive the active state at the same time.
If POL(n) = 0, POL(n+1) = 0, and the deadtime is enabled, then when the channel (n)
match (FTM counter = C(n)V) occurs, the channel (n) output remains at the low value
until the end of the deadtime delay when the channel (n) output is set. Similarly, when the
channel (n+1) match (FTM counter = C(n+1)V) occurs, the channel (n+1) output remains
at the low value until the end of the deadtime delay when the channel (n+1) output is set.
See the following figures.
If POL(n) = 1, POL(n+1) = 1, and the deadtime is enabled, then when the channel (n)
match (FTM counter = C(n)V) occurs, the channel (n) output remains at the high value
until the end of the deadtime delay when the channel (n) output is cleared. Similarly,
Functional description
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
992 NXP Semiconductors

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NXP Semiconductors K22F series and is the answer not in the manual?

NXP Semiconductors K22F series Specifications

General IconGeneral
BrandNXP Semiconductors
ModelK22F series
CategoryController
LanguageEnglish

Related product manuals