EasyManua.ls Logo

NXP Semiconductors K22F series - OTG Control Register (Usbx_Otgctl)

NXP Semiconductors K22F series
1407 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
USBx_OTGSTAT field descriptions (continued)
Field Description
6
ONEMSECEN
This bit is reserved for the 1ms count, but it is not useful to software.
5
LINESTATESTABLE
Indicates that the internal signals that control the LINE_STATE_CHG field of OTGISTAT are stable for
at least 1 ms. This bit is used to provide a hardware debounce of the linestate in detection of Connect,
Disconnect and Resume signaling. First read LINE_STATE_CHG field and then read this field. If this
field reads as 1, then the value of LINE_STATE_CHG can be considered stable.
0 The LINE_STAT_CHG bit is not yet stable.
1 The LINE_STAT_CHG bit has been debounced and is stable.
4
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
3
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
0 The VBUS voltage is below the B session valid threshold
1 The VBUS voltage is above the B session valid threshold.
2
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
0 The VBUS voltage is above the B session end threshold.
1 The VBUS voltage is below the B session end threshold.
1
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
0
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
0 The VBUS voltage is below the A VBUS Valid threshold.
1 The VBUS voltage is above the A VBUS Valid threshold.
43.4.8 OTG Control register (USBx_OTGCTL)
Controls the operation of VBUS and Data Line termination resistors.
Address:
4007_2000h base + 1Ch offset = 4007_201Ch
Bit 7 6 5 4 3 2 1 0
Read
DPHIGH
0
DPLOW DMLOW
0
OTGEN
0
Write
Reset
0 0 0 0 0 0 0 0
USBx_OTGCTL field descriptions
Field Description
7
DPHIGH
D+ Data Line pullup resistor enable
0 D+ pullup resistor is not enabled
1 D+ pullup resistor is enabled
Table continues on the next page...
Chapter 43 Universal Serial Bus Full Speed OTG Controller (USBFSOTG)
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
NXP Semiconductors 1089

Table of Contents

Related product manuals