EasyManuals Logo

NXP Semiconductors K22F series User Manual

NXP Semiconductors K22F series
1407 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #864 background imageLoading...
Page #864 background image
Tstup or until SC[VREFST] = 1 when the chop oscillator is not enabled. If the chop
oscillator is being used, you must wait the time specified by Tchop_osc_stup (chop
oscillator start up time) to ensure the VREF output has stabilized.
In this mode, a 100 nF capacitor is required to connect between the VREF_OUT pin and
VSSA.
37.3.2.3 SC[MODE_LV] = 10
The internal VREF bandgap is on. The low power buffer is enabled to generate a buffered
1.2 V voltage to VREF_OUT. It can also be used as a reference to internal analog
peripherals such as an ADC channel or analog comparator input.
If this mode is entered from the standby mode (SC[MODE_LV] = 00, SC[VREFEN] = 1)
there will be a delay before the buffer output is settled at the final value. This is the buffer
start up delay (Tstup) and the value is specified in the appropriate device data sheet. If
this mode is entered when the VREF module is enabled then you must wait the longer of
Tstup or until SC[VREFST] = 1 when the chop oscillator is not enabled. If the chop
oscillator is being used, you must wait the time specified by Tchop_osc_stup (chop
oscillator start up time) to ensure the VREF output has stabilized.
In this mode, a 100 nF capacitor is required to connect between the VREF_OUT pin and
VSSA.
37.3.2.4
SC[MODE_LV] = 11
Reserved
37.3.3
Internal voltage regulator
The VREF module contains an internal voltage regulator that can be enabled to provide
additional supply noise rejection. It is recommended that when possible, this regulator be
enabled to provide the optimum VREF performance.
If the internal voltage regulator is being used, the chop oscillator must also be enabled. A
specific sequence must be followed when enabling the internal regulator as follows:
1. Enable the chop oscillator (VREF_TRM[CHOPEN] = 1)
2. Configure the VREF_SC register to the desired settings with the internal regulator
disabled, VREF_SC[REGEN] = 0
3. Wait > 300ns
Functional Description
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
864 NXP Semiconductors

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NXP Semiconductors K22F series and is the answer not in the manual?

NXP Semiconductors K22F series Specifications

General IconGeneral
BrandNXP Semiconductors
ModelK22F series
CategoryController
LanguageEnglish

Related product manuals