Chapter 6
Reset and Boot
6.1 Introduction
The following reset sources are supported in this MCU:
Table 6-1. Reset sources
Reset sources Description
POR reset • Power-on reset (POR)
System resets • External pin reset (PIN)
• Low-voltage detect (LVD)
• Computer operating properly (COP) watchdog reset
• Low leakage wakeup (LLWU) reset
• Multipurpose clock generator loss of clock (LOC) reset
• Multipurpose clock generator loss of lock (LOL) reset
• Stop mode acknowledge error (SACKERR)
• Software reset (SW)
• Lockup reset (LOCKUP)
• EzPort reset
• MDM DAP system reset
Debug reset • JTAG reset
• nTRST reset
Each of the system reset sources has an associated bit in the system reset status (SRS)
registers. See the Reset Control Module for register details.
The MCU exits reset in functional mode that is controlled by
EZP_CS pin to select
between the single chip (default) or serial flash programming (EzPort) modes. See Boot
options for more details.
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
NXP Semiconductors 169
To Next Page
Loading...
