NXP Semiconductors K22F series - Chapter 11 Port Control and Interrupts (PORT); Introduction; Overview; Features

Chapter 11
Port Control and Interrupts (PORT)
11.1 Introduction
NOTE
For the chip-specific implementation details of this module's
instances, see the chip configuration information.
11.2
Overview
The Port Control and Interrupt (PORT) module provides support for port control, digital
filtering, and external interrupt functions.
Most functions can be configured independently for each pin in the 32-bit port and affect
the pin regardless of its pin muxing state.
There is one instance of the PORT module for each port. Not all pins within each port are
implemented on a specific device.
11.2.1
Features
The PORT module has the following features:
• Pin interrupt
• Interrupt flag and enable registers for each pin
• Support for edge sensitive (rising, falling, both) or level sensitive (low, high)
configured per pin
• Support for interrupt or DMA request configured per pin
• Asynchronous wake-up in low-power modes
• Pin interrupt is functional in all digital pin muxing modes
• Digital input filter on selected pins
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
NXP Semiconductors 239