46.4.6.3 Stop Detect Interrupt
When the stop status is detected on the I
2
C bus, the STOPF bit is set to 1. The CPU is
interrupted, provided the IICIE and SSIE bits are both set to 1.
46.4.6.4 Exit from low-power/stop modes
The slave receive input detect circuit and address matching feature are still active on low
power modes (wait and stop). An asynchronous input matching slave address or general
call address brings the CPU out of low power/stop mode if the interrupt is not masked.
Therefore, TCF and IAAS both can trigger this interrupt.
46.4.6.5 Arbitration lost interrupt
The I2C is a true multimaster bus that allows more than one master to be connected on it.
If two or more masters try to control the bus at the same time, the relative priority of the
contending masters is determined by a data arbitration procedure. The I2C module asserts
the arbitration-lost interrupt when it loses the data arbitration process and the ARBL bit
in the Status Register is set.
Arbitration is lost in the following circumstances:
1. SDA is sampled as low when the master drives high during an address or data
transmit cycle.
2. SDA is sampled as low when the master drives high during the acknowledge bit of a
data receive cycle.
3. A START cycle is attempted when the bus is busy.
4. A repeated START cycle is requested in slave mode.
5. A STOP condition is detected when the master did not request it.
The ARBL bit must be cleared (by software) by writing 1 to it.
Functional description
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
1208 NXP Semiconductors
To Next Page
Loading...
Need help?
General
