EasyManua.ls Logo

NXP Semiconductors K22F series - Page 1342

NXP Semiconductors K22F series
1407 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
I2Sx_TCSR field descriptions (continued)
Field Description
Enables/disables the transmitter. When software clears this field, the transmitter remains enabled, and this
bit remains set, until the end of the current frame.
0 Transmitter is disabled.
1 Transmitter is enabled, or transmitter has been disabled and has not yet reached end of frame.
30
STOPE
Stop Enable
Configures transmitter operation in Stop mode. This field is ignored and the transmitter is disabled in all
low-leakage stop modes.
0 Transmitter disabled in Stop mode.
1 Transmitter enabled in Stop mode.
29
DBGE
Debug Enable
Enables/disables transmitter operation in Debug mode. The transmit bit clock is not affected by debug
mode.
0 Transmitter is disabled in Debug mode, after completing the current frame.
1 Transmitter is enabled in Debug mode.
28
BCE
Bit Clock Enable
Enables the transmit bit clock, separately from the TE. This field is automatically set whenever TE is set.
When software clears this field, the transmit bit clock remains enabled, and this bit remains set, until the
end of the current frame.
0 Transmit bit clock is disabled.
1 Transmit bit clock is enabled.
27–26
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
25
FR
FIFO Reset
Resets the FIFO pointers. Reading this field will always return zero. FIFO pointers should only be reset
when the transmitter is disabled or the FIFO error flag is set.
0 No effect.
1 FIFO reset.
24
SR
Software Reset
When set, resets the internal transmitter logic including the FIFO pointers. Software-visible registers are
not affected, except for the status registers.
0 No effect.
1 Software reset.
23–21
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
20
WSF
Word Start Flag
Indicates that the start of the configured word has been detected. Write a logic 1 to this field to clear this
flag.
0 Start of word not detected.
1 Start of word detected.
Table continues on the next page...
Memory map and register definition
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
1342 NXP Semiconductors

Table of Contents

Related product manuals