EasyManuals Logo

NXP Semiconductors K22F series User Manual

NXP Semiconductors K22F series
1407 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1393 background imageLoading...
Page #1393 background image
51.4.4.3 SAMPLE instruction
The SAMPLE instruction obtains a sample of the system data and control signals present
at the MCU input pins and just before the boundary scan register cells at the output pins.
This sampling occurs on the rising edge of TCK in the Capture-DR state when the
SAMPLE instruction is active. The sampled data is viewed by shifting it through the
boundary scan register to the TDO output during the Shift-DR state. There is no defined
action in the Update-DR state. Both the data capture and the shift operation are
transparent to system operation.
51.4.4.4 EXTEST External test instruction
EXTEST selects the boundary scan register as the shift path between TDI and TDO. It
allows testing of off-chip circuitry and board-level interconnections by driving preloaded
data contained in the boundary scan register onto the system output pins. Typically, the
preloaded data is loaded into the boundary scan register using the SAMPLE/PRELOAD
instruction before the selection of EXTEST. EXTEST asserts the internal system reset for
the MCU to force a predictable internal state while performing external boundary scan
operations.
51.4.4.5
HIGHZ instruction
HIGHZ selects the bypass register as the shift path between TDI and TDO. While
HIGHZ is active all output drivers are placed in an inactive drive state (e.g., high
impedance). HIGHZ also asserts the internal system reset for the MCU to force a
predictable internal state.
51.4.4.6
CLAMP instruction
CLAMP allows the state of signals driven from MCU pins to be determined from the
boundary scan register while the bypass register is selected as the serial path between
TDI and TDO. CLAMP enhances test efficiency by reducing the overall shift path to a
single bit (the bypass register) while conducting an EXTEST type of instruction through
the boundary scan register. CLAMP also asserts the internal system reset for the MCU to
force a predictable internal state.
Chapter 51 JTAG Controller (JTAGC)
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
NXP Semiconductors 1393

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NXP Semiconductors K22F series and is the answer not in the manual?

NXP Semiconductors K22F series Specifications

General IconGeneral
BrandNXP Semiconductors
ModelK22F series
CategoryController
LanguageEnglish

Related product manuals