GetPropertyResponse: The GetPropertyResponse packet is sent by the target in
response to the host query that uses the GetProperty command. The GetPropertyResponse
packet contains the framing packet data and the command packet data, with the
command/response tag set to a GetPropertyResponse tag value (0xA7).
The parameter count field in the header is set to greater than 1, to always include the
status code and one or many property values.
Table 13-13. GetPropertyResponse Parameters
Byte # Value Parameter
0 - 3 Status code
4 - 7 Property value
. . . . . .
Can be up to maximum 6 property values, limited to the size of the 32-bit
command packet and property type.
ReadMemoryResponse: The ReadMemoryResponse packet is sent by the target in
response to the host sending a ReadMemory command. The ReadMemoryResponse
packet contains the framing packet data and the command packet data, with the
command/response tag set to a ReadMemoryResponse tag value (0xA3), the flags field
set to kCommandFlag_HasDataPhase (1).
The parameter count set to 2 for the status code and the data byte count parameters shown
below.
Table 13-14. ReadMemoryResponse Parameters
Byte # Parameter Descripton
0 - 3 Status code The status of the associated Read Memory command.
4 - 7 Data byte count The number of bytes sent in the data phase.
FlashReadOnceResponse:The FlashReadOnceResponse packet is sent by the target in
response to the host sending a FlashReadOnce command. The FlashReadOnceResponse
packet contains the framing packet data and the command packet data, with the
command/response tag set to a FlashReadOnceResponse tag value (0xAF), and the flags
field set to 0. The parameter count is set to 2 plus the number of words requested to be
read in the FlashReadOnceCommand.
Table 13-15. FlashReadOnceResponse Parameters
Byte # Value Parameter
0 – 3 Status Code
Table continues on the next page...
Chapter 13 Kinetis Flashloader
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
NXP Semiconductors 307
To Next Page
Loading...
Need help?
General
