22.5.8.2 Errors
To handle source-address errors (SAE), perform the following steps.
1. Fix the addressing error.
2. Clear the error bit in Error Register (DMA_ERR).
3. Start the channel in a normal fashion.
NOTE
Error Status Register (DMA_ES) is read-only; the bits cannot
be cleared. It saves the last recorded error. The VLD bit shows
the user whether any error bits in the Error Register are set, thus
indicating an error occurred that hasn't been cleared.
Initialization/application information
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
508 NXP Semiconductors
To Next Page
Loading...
Need help?
General
