Ricoh MP C2504 - Page 1699

6-011-008 Original Width 5 ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when there is a paper at sensor area.
6-011-009 Original Detection ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when original is set.
6-011-010 Separation Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when there is a paper at sensor area.
6-011-011 Skew Correction ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when there is a paper at sensor area.
6-011-012 Scan Entrance Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when there is a paper at sensor area.
6-011-013 Registration Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when there is a paper at sensor area.
6-011-014 Exit Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when there is a paper at sensor area.
6-011-015 Feed Cover Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when cover is open.
6-011-016 Lift Up Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when lift up.
6-011-018 Pick-Up Roller HP Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when pick up roller is not in home position.
6-011-021 Bottom Plate HP Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when bottom plate is not in home position.
6-011-022 Bottom Plate Position Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when pick up roller is not in the correct
position.
3. Engine SP Mode Tables
464