bit 3 [PS] PS Criteria Pattern3 Pattern1
Change the number of PS criterion used by the PS interpreter to determine
whether a job is PS data or not.
For details, refer to page 675 "Printing Features".
bit 4
Increase max. number of stored jobs.
Disabled
(100)
Enabled (750)
Changes the maximum number of jobs that can be stored on the HDD. The
default (disabled) is 100. If this is enabled, the max. will be raised to 750 or
1000 depending on the model.
bit 5 DFU - -
bit 6 Method for determining the image rotation
for the edge to bind on.
Disabled Enabled
If enabled, the image rotation will be performed as they were in the
specifications of older models for the binding of pages of mixed orientation
jobs.
The old models are below:
- PCL: Pre-04A models
- PS/PDF/RPCS:Pre-05S models
bit 7
Letterhead mode printing Disabled
Enabled
(Duplex)
Routes all pages through the duplex unit.
If this is disabled, simplex pages or the last page of an odd-paged duplex
job, are not routed through the duplex unit. This could result in problems with
letterhead/pre-printed pages.
Only affects pages specified as Letterhead paper.
1001 [Bit Switch]
Printer Service Menu
657
To Next Page
Loading...
