bit 3 PCL/PS bypass tray paper rotation (SEF/
LEF)
Disabled Enabled
This bitsw causes the device to revert to the behavior of previous generations.
It only takes effect if "Bypass Tray Setting Priority" = "Driver/Command".
Previous spec (bitsw=1): If a standard sized paper mismatch occurred in the
bypass tray, the MFP always prompted for SEF paper.
If this bitsw=0 (default) then in the event of a standard sized paper mismatch,
the MFP will always prompt for paper of the rotation (SEF/LEF) determined
by the MFP bypass tray paper setting or by the bypass tray sensor.
bit 4 Timing of the PJL Status ReadBack (JOB
END) when printing multiple collated copies.
Disable Enable
This bitsw determines the timing of the PJL USTATUS JOB END sent when
multiple collated copies are being printed.
0 (default): JOB END is sent by the device to the client after the first copy has
completed printing. This causes the page counter to be incremented after the
first copy and then again at the end of the job.
1: JOB END is sent by the device to the client after the last copy has finished
printing. This causes the page counter to be incremented at the end of each
job.
Printer Service Menu
661
To Next Page
Loading...
