DocID024597 Rev 3 699/1693
RM0351 Touch sensing controller (TSC)
709
23.4 TSC low-power modes
23.5 TSC interrupts
Table 137. Effect of low-power modes on TSC
Mode Description
Sleep No effect. Peripheral interrupts cause the device to exit Sleep mode.
Low power run No effect.
Low power sleep No effect. Peripheral interrupts cause the device to exit Low-power sleep mode.
Stop 0 / Stop 1
Peripheral registers content is kept.
Stop 2
Standby
Powered-down. The peripheral must be reinitialized after exiting Standby or
Shutdown mode.
Shutdown
Table 138. Interrupt control bits
Interrupt event
Enable
control bit
Event flag
Clear flag
bit
Exit the
Sleep
mode
Exit the
Stop mode
Exit the
Standby
mode
End of acquisition EOAIE EOAIF EOAIC yes no no
Max count error MCEIE MCEIF MCEIC yes no no
To Next Page
Loading...
Need help?
General
