Peripherals interconnect matrix RM0351
286/1693 DocID024597 Rev 3
9 Peripherals interconnect matrix
9.1 Introduction
Several peripherals have direct connections between them.
This allows autonomous communication and or synchronization between peripherals,
saving CPU resources thus power supply consumption.
In addition, these hardware connections remove software latency and allow design of
predictable system.
Depending on peripherals, these interconnections can operate in Run, Sleep, Low-power
run and sleep, Stop 0, Stop 1 and Stop 2 modes.
9.2 Connection summary
Table 35. STM32L4x6 peripherals interconnect matrix
(1)
(2)
Source
Destination
TIM1
TIM8
TIM2
TIM3
TIM4
TIM5
TIM6
TIM7
TIM15
TIM16
TIM17
LPTIM1
LPTIM2
ADC1
ADC2
ADC3
DFSDM
OPAMP1
OPAMP2
DAC1
DAC2
COMP1
COMP2
DMA
IRTIM
TIM1 - 1111- - - 1 - - - - 2225 - - - - 9 - - -
TIM8
- - 1 - 11- - - - - - - 2225 - - 44 - 9 - -
TIM2 11
- 111- - - - - - - 222 - - - 449 - - -
TIM3 1
- 1 - 11- - 1 - - - - 2225 - - - - 99 - -
TIM4 1111
- 1 - - - - - - - 2225- - 44 - - - -
TIM5
- 1 - - - - - - - - - - - - - - - - - 44 - - - -
TIM6
- - - - - - - - - - - - - 2225- - 44 - - - -
TIM7
- - - - - - - - - - - - - - - - 5 - - 44 - - - -
TIM15 1
- - 1 - - - - - - - - - 222 - - - - - - 9 - -
TIM16
- - - - - - - - 1 - - - - - - - 5 - - - - - - - 15
TIM17
- - - - - - - - 1 - - - - - - - - - - - - - - - 15
LPTIM1
- - - - - - - - - - - - - - - - - - - - - - - - -
LPTIM2
- - - - - - - - - - - - - - - - - - - - - - - - -
ADC1 3
- - - - - - - - - - - - - 10 - - - - - - - - - -
ADC2
- 3 - - - - - - - - - - - - - - - - - - - - - - -
ADC3 33
- - - - - - - - - - - - - - - - - - - - - - -
DFSDM 66
- - - - - - 666- - - - - - - - - - - - - -
T. S e ns o r
- - - - - - - - - - - - - 12 - 12 - - - - - - - - -
VBAT
- - - - - - - - - - - - - 12 - 12 - - - - - - - - -