EasyManuals Logo

ST STM32L4x6 User Manual

ST STM32L4x6
1693 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #346 background imageLoading...
Page #346 background image
Flexible static memory controller (FSMC) RM0351
346/1693 DocID024597 Rev 3
transactions are allowed (the controller reads the entire 16-bit memory word and
uses only the required byte).
Wrap support for NOR Flash/PSRAM
Wrap burst mode for synchronous memories is not supported. The memories must be
configured in linear burst mode of undefined length.
Configuration registers
The FMC can be configured through a set of registers. Refer to Section 14.5.6, for a
detailed description of the NOR Flash/PSRAM controller registers. Refer to Section 14.6.7,
for a detailed description of the NAND Flash registers.
14.4 External device address mapping
From the FMC point of view, the external memory is divided into fixed-size banks of
256 Mbytes each (see Figure 30):
Bank 1 used to address up to 4 NOR Flash memory or PSRAM devices. This bank is
split into 4 NOR/PSRAM subbanks with 4 dedicated Chip Selects, as follows:
Bank 1 - NOR/PSRAM 1
Bank 1 - NOR/PSRAM 2
Bank 1 - NOR/PSRAM 3
Bank 1 - NOR/PSRAM 4
Bank 3 used to address NAND Flash memory devices.The MPU memory attribute for
this space must be reconfigured by software to Device.
For each bank the type of memory to be used can be configured by the user application
through the Configuration register.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ST STM32L4x6 and is the answer not in the manual?

ST STM32L4x6 Specifications

General IconGeneral
BrandST
ModelSTM32L4x6
CategoryMicrocontrollers
LanguageEnglish

Related product manuals