ST STM32L4x6 User Manual

DocID024597 Rev 3 797/1693
RM0351 Advanced-control timers (TIM1/TIM8)
856
26.3.19 6-step PWM generation
When complementary outputs are used on a channel, preload bits are available on the
OCxM, CCxE and CCxNE bits. The preload bits are transferred to the shadow bits at the
COM commutation event. Thus you can program in advance the configuration for the next
step and change the configuration of all the channels at the same time. COM can be
generated by software by setting the COM bit in the TIMx_EGR register or by hardware (on
TRGI rising edge).
A flag is set when the COM event occurs (COMIF bit in the TIMx_SR register), which can
generate an interrupt (if the COMIE bit is set in the TIMx_DIER register) or a DMA request
(if the COMDE bit is set in the TIMx_DIER register).
The Figure 238 describes the behavior of the OCx and OCxN outputs when a COM event
occurs, in 3 different examples of programmed configurations.
Figure 238. 6-step generation, COM example (OSSR=1)
&&5[
2&[
2&[1
:ULWH&20WR
&RXQWHU&17
2&[5()
&20HYHQW
&&[( 
&&[1( 
2&[0 
2&[
2&[1
&&[( 
&&[1( 
2&[
2&[1
&&[( 
&&[1( 
2&[0 
([DPSOH

([DPSOH 
([DPSOH

ZULWH2&[0WR
&&[( 
&&[1( 
2&[0 IRUFHGLQDFWLYH
&&[( 
&&[1( 
2&[0 IRUFHGLQDFWLYH
:ULWH&&[1(WR
DQG2&[0WR
ZULWH&&[1(WR
DQG2&[0WR
&&[( 
&&[1( 
2&[0 IRUFHGLQDFWLYH
DL
2&[0 

ST STM32L4x6 Specifications

General

Brand	ST
Model	STM32L4x6
Category	Microcontrollers
Language	English