Advanced-control timers (TIM1/TIM8) RM0351
830/1693 DocID024597 Rev 3
Bit 15 CC4NP: Capture/Compare 4 complementary output polarity
Refer to CC1NP description
Bit 14 Reserved, must be kept at reset value.
Bit 13 CC4P: Capture/Compare 4 output polarity
Refer to CC1P description
Bit 12 CC4E: Capture/Compare 4 output enable
Refer to CC1E description
Bit 11 CC3NP: Capture/Compare 3 complementary output polarity
Refer to CC1NP description
Bit 10 CC3NE: Capture/Compare 3 complementary output enable
Refer to CC1NE description
Bit 9 CC3P: Capture/Compare 3 output polarity
Refer to CC1P description
Bit 8 CC3E: Capture/Compare 3 output enable
Refer to CC1E description
Bit 7 CC2NP: Capture/Compare 2 complementary output polarity
Refer to CC1NP description
Bit 6 CC2NE: Capture/Compare 2 complementary output enable
Refer to CC1NE description
Bit 5 CC2P: Capture/Compare 2 output polarity
Refer to CC1P description
Bit 4 CC2E: Capture/Compare 2 output enable
Refer to CC1E description
Bit 3 CC1NP: Capture/Compare 1 complementary output polarity
CC1 channel configured as output:
0: OC1N active high.
1: OC1N active low.
CC1 channel configured as input:
This bit is used in conjunction with CC1P to define the polarity of TI1FP1 and TI2FP1. Refer to
CC1P description.
Note: This bit is not writable as soon as LOCK level 2 or 3 has been programmed (LOCK bits
in TIMx_BDTR register) and CC1S=”00” (channel configured as output).
Note: On channels having a complementary output, this bit is preloaded. If the CCPC bit is
set in the TIMx_CR2 register then the CC1NP active bit takes the new value from the
preloaded bit only when a Commutation event is generated.
Bit 2 CC1NE: Capture/Compare 1 complementary output enable
0: Off - OC1N is not active. OC1N level is then function of MOE, OSSI, OSSR, OIS1, OIS1N
and CC1E bits.
1: On - OC1N signal is output on the corresponding output pin depending on MOE, OSSI,
OSSR, OIS1, OIS1N and CC1E bits.
Note: On channels having a complementary output, this bit is preloaded. If the CCPC bit is
set in the TIMx_CR2 register then the CC1NE active bit takes the new value from the
preloaded bit only when a Commutation event is generated.
To Next Page
Loading...
Need help?
General
