NXP Semiconductors K22F series - Page 1398

• In "LPUART Peripheral" section (or UART section, depending on your specific device), added autobaud ping packet
accuracy requirement.
• In FlashEraseAll command section, in "FlashEraseAll Command Packet Format" table, added MemoryID parameter to
command packet parameters
• RAM Memory map was removed
• In "FillMemory command" section, corrected missing text for "Writing to flash requires the start address to be"
• In "Get/SetProperty Command Properties" section, table "Properties used by Get/SetProperty Commands, sorted by
Value", updated the description of RAMStartAddress and RAMSizeInBytes properties.
A.14 RCM changes
• Updated the name of AN4503 to AN4503: Power Management for Kinetis MCUs
A.15 SMC changes
• Updated the name of AN4503 to “AN4503: Power Management for Kinetis MCUs”
• Removed RAM2 content.
A.16 PMC changes
• Updated the name of AN4503 to “AN4503: Power Management for Kinetis MCUs”
A.17 LLWU changes
• Updated the name of AN4503 to “AN4503: Power Management for Kinetis MCUs”
A.18 MCM changes
• No substantial content changes
A.19 Crossbar switch module changes
• In Features added phrase to bullet re. arbitration to see chip-specific information.
RCM changes
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
1398 NXP Semiconductors